GX35 Gas Concrete Wet Screed Power Screed Cement 37.7CC 4 Cycle Gasoline Engine

Description

GX35 37.7cc Gas Concrete Wet Screed Power Screed Cement
Concrete Power Screed without any blade
Suitable with 1-6M blade
The power screed is ideal for smoothing, leveling, and placing concrete on a horizontal surface. It is powered by a 4 stroke motor
gas powered screeds not only are easier to use, require less manpower but also do a majority of the bull floating too. The ergonomical design and rubber isolators reduce vibration making the job easier for the operator.
Screed is the best solution for cutting the time to 1/4 compared to the traditional method while at the same time leaving a superior finish.
Power Screed Specs
Powered by 37.7cc Commercial Grade Engine
and comes with vibration isolators for comfort
Ergonomically Designed for easy use
37.7cc. 4 cycle gasoline engine power a well engineered and field proven eccentric system to frequencies up to 5200 rpm.
Swapping out beam lengths is easy which assures that you always have the right length for your project.
A strong, light weight frame allows the blades to be changed in seconds.
Lightweight Power unit and frame making it easy to maneuver and transport around the site.
Kick stand comes standard for keeping the motor upright and out of the cement.
Specification
Gasoline vibrator parameter:
Model GX35
Power 1.2HP
Rotate Speed 5200r/min
Length 2-6m
Weight 25kg
Drive system Flexible shaft
Engine Four-stroke air-cooled gasoline engine
Gasoline Volume 0.65L
Dimension 2500*1400*960
Electric vibrator parameter
Power Force 100-400N
Engine 3/single Phase
Frequency 4500HZ
Power 0.065KW
Rotate Speed 4500r/min
Voltage 380v/220v
Shaft Length 1-4m
Driven system Electric vibrator
Paving speed 30m/h
Walking Speed 30m/h
Weight 15kg
Paving Thickness 10cm
Dimension 600*460*760
3. Structure & Working Principle
Concrete Vibrator mainly made up by the motor, transmission, scraper, vibrator, handle five major components.
Working principle: Concrete vibrator, is a vibrator floating on the concrete surface for direct tamping. It is attached to the vibrator mounted on the plate, work, through the plate chassis vibration will be introduced into the interior from the surface and the concrete fizzy. This type of vibrator is mainly applied to a large area of vibration, the thickness of the small cement concrete pavement, deck and concrete precast panels, etc.
4. Caution
It should be noted that the oil cup add 79ml oil chassis, do not add more, otherwise it is easy to reverse the interior of the cylinder, causing smoke and other adverse conditions, this time put the machine down, pour out the oil, the machine can then run for a while Back to normal. Change the oil every three days and remove the air bubbles before starting.
On Jun-06-21 at 09:29:07 PDT, seller added the following information: